As we write directly into the batch in system memory, we do not need to
write first to the stack (as was to avoid read back through the GTT)
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
In preparation for a greater change, use the color_calc_state_bo already
provisioned for this purpose.
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
Rather than performing lots of little writes to update the common bo
upon each update, write those into a static buffer and flush that when
full (or at the end of the batch). Doing so gives a dramatic performance
improvement over and above using mmaped access.
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
Rather than performing a blit to completely overwrite a busy bo, simply
discard it and create a new one with the fresh data.
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
Dynamic arrays have the tendency to be small and so allocating a bo for
each one is overkill and we can exploit many efficiency gains by packing
them together.
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
Dynamic draw buffers are used by clients for temporary arrays and for
uploading normal vertex arrays. By keeping the data in memory, we can
avoid reusing active buffer objects and reallocate them as they are
changed. This is important for Sandybridge which can not issue blits
within a batch and so ends up flushing the batch upon every update, that
is each batch only contains a single draw operation (if using dynamic
arrays or regular arrays from system memory).
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
Following a GPU hang, or other error, the render target is not likely to
have an allocated BO and so we must fallback to avoid using it.
Bugzilla: https://bugs.freedesktop.org/show_bug.cgi?id=32534
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
Fix a typo which meant that --enable-shared-glapi didn't actually cause a shared glapi to be built
Signed-off-by: Jon TURNEY <jon.turney@dronecode.org.uk>
This behavior was last when moving the transfers to the contexts.
This fixes several piglit failures, which were reading the color renderbuffer
before the draw operations were emitted.
This is a temporary workaround. It fixes sauerbrauten with shaders enabled.
I guess we might be changing vertex attribs somewhere and not updating
the appropriate dirty flags, therefore we can't rely on them for now.
Or maybe we need to make this state dependent on some other flags too.
More info:
https://bugs.freedesktop.org/show_bug.cgi?id=34378
When we drop the in_swtnl_draw flag, we must force a rerun of
update_need_swtnl to reset the need_swtnl flag to its correct value outside
of a swtnl vbo draw.
Signed-off-by: Thomas Hellstrom <thellstrom@vmware.com>
If we hit the pipe_get/put_tile() path for setting up the glCopyPixels
texture we were passing the wrong x/y position to pipe_get_tile().
The x/y position was already accounted for in the pipe_get_transfer()
call so we were effectively reading from 2*readX, 2*readY.
NOTE: This is a candidate for the 7.9 and 7.10 branches.
