Add new Reload D-Bus command to reload NetworkManager configuration.
For now, this is like sending SIGHUP to the process. There are several
advantages here:
- it is guarded via PolicyKit authentication while signals
can only be sent by root.
- the user can wait for the reload to be complete instead of sending
an asynchronous signal. For now, we operation completes after
nm_config_reload() returns, but later we could delay the response
further until specific parts are fully reloaded.
- SIGHUP reloads everything including re-reading configuration from
disk while SIGUSR1 reloads just certain parts such as writing out DNS
configuration anew.
Now, the Reload command has a flags argument which is more granular
in selecting parts which are to be reloaded. For example, via
signals the user can:
1) send SIGUSR1: this writes out the DNS configuration to
resolv.conf and possibly reloads other parts without
re-reading configuration and without restarting the DNS plugin.
2) send SIGHUP: this reloads configuration from disk,
writes out resolv.conf and restarts the DNS plugin.
There is no way, to only restart the DNS plugin without also reloading
everything else.
When performing NM package upgrade the new version of nmcli will be immediately
available while NM daemon will not, as it would not restart in order to avoid
to disrupt connectivity. This could create issues with tools leveraging
on nmcli output (till reboot). As apart from this case it is very unlikely
that a user can have this nmcli / NM daemon version mismatch situation,
the check could cause more harm than benefit in real user case
scenarios.
https://bugzilla.redhat.com/show_bug.cgi?id=1291785
The new object type represents tunnels over IPv4 and IPv6.
We have a single setting type (NMSettingIPTunnel) for tunnels and it
can't be shared among different device factories. So we define also a
single device type for all tunnels.
This new object will also represent GRE tunnels, which before were
instantiated as NMDeviceGre and had a ".Device.Gre" D-Bus
interface. This commit introduces a change in behavior.
Add a generic NMSettingTunnel which describes properties of tunnels
over IPv4 and IPv6 (GRE, SIT, IPIP, IPIP6, IP6GRE, etc.). Since those
tunnel types all have similar properties it makes sense to have a
single setting type for them.
Makes Zanata unhappy, in the Java way.
for i in po/*.po; do awk '
/^" 0 = / { print "\"%s\""; n=1; next; }
/^" 8 = / { n=0; next }
{ if (!n) print }' $i >x
mv x $i
done
Fixes: 3641ddb00a
msgmerge complains with
"warning: internationalized messages should not contain the '\r' escape sequence"
Found by Anders Jonsson <anders.jonsson@norsjovallen.se>
https://bugzilla.gnome.org/show_bug.cgi?id=758102
