Since one test read in a file, wrote it out, and read it in again, we
have to be careful of whether srcdir == builddir or not. If it doesn't,
then we need to remove the written-out connection file. If it does, then
we don't want to remove that written-out connection file because it's
tracked by SCM. Avoid the whole problem by writing it out to a separate
directory that we can always delete it from.
And remove cargo-culted internal stuff which is no longer needed.
The ifcfg-rh sha1 stuff wasn't even used anymore after the move to
certificate paths.
The ipw2x00 drivers won't be converted over to the kernel's rfkill
subsystem until 2.6.33, and thus listening for udev rfkill change
events on these devices doesn't work. So until then, poll rfkill
state for ipw2x00 devices every few seconds in addition to listening
to other rfkill sources.
Shouldn't be allowing scan requests when associating or when the
supplicant is otherwise busy doing something else.
Older fullmac cards are much more likely to run into this problem
since they usually take longer to connect; since they take so
long, NM may sometimes request a scan during association or
during DHCP which can cause the card to miss DHCP replies. I've
never seen this happen with mac80211 drivers though.
Since rfkill state is saved but not acted upon during sleep
(since NM shouldn't be touching devices while sleeping) we have to
remember to act on the new state when waking up.
3rd patch in a series with:
0bbdc6b0fcb135fa3265
With NM 0.8 the system settings service was integrated into NM and
thus nm_connection_clear_secrets() acts directly on the system
settings plugins' NMConnection objects. So when NM cleared secrets
(for example after determining that they might be bad in a device's
stage2 handler), we completely lost the secrets forever.
With this commit, the secrets are now cached and updated whenever
the connection is updated, and thus are again available to send to
NetworkManager when needed.
nm_connection_replace_settings() replaces the connection's settings
but doesn't allow interception of the new settings. Plugins would then
send out the update signal, but secrets are scrubbed out of them to
ensure secrets aren't leaked out into D-Bus signals.
With NM 0.8 the system settings service was integrated into NM and
thus nm_connection_clear_secrets() acts directly on the system
settings plugins' NMConnection objects. So when NM cleared secrets
(for example after determining that they might be bad in a device's
stage2 handler), we completely lost the secrets forever.
Adding this function allows the system settings service to hook into
the connection updates when the plugin connection's backing storage
(like config files or whatever) changes and cache the secrets for
use in NMSettingsConnectionInterface get_secrets() requestes.
Turn DHCP and DNS debugging on with NM_DNSMASQ_DEBUG.
Without --strict-order, dnsmasq will round-robin queries which in
the case of VPN connections may result in the query going to the
non-VPN nameserver. Also, allow dnsmasq to poll resolv.conf for
nameserver updates so that when the default connection changes,
it knows about the new nameservers.
If the supplicant interface became ready but the device was still
UNAVAILABLE, requesting a scan before transitioning to DISCONNECTED
would just fail because can_scan() returns FALSE when the device's
state is not >= DISCONNECTED. Change device state first so that
doesn't happen.
