v3dv: handle QUNIFORM_FB_LAYERS

There is a bit of a corner case here for secondary buffers that
don't inherit framebuffer information, since those won't have
access to the number of layers in the framebuffer by the time
we get here. Since we only emit this to sanitize the value of
gl_Layer produced from geometry shaders, I think it is probably
fine to lie about it and just use the maximum number of layers
we support. The only issue with that is that broken shaders that
emit out of bounds layer indices (which the spect states may lead
to unfined shading results) may cause undefined results.

In the future we could do better and patch the uniform streams
later when the secondary is executed inside a primary, since we
will have the required framebuffer information at that point,
but for now this seems like a reasonable compromise.

Reviewed-by: Alejandro Piñeiro <apinheiro@igalia.com>
Part-of: <https://gitlab.freedesktop.org/mesa/mesa/-/merge_requests/11783>

src/broadcom/vulkan/v3dv_uniforms.c

@@ -487,6 +487,45 @@ v3dv_write_uniforms_wg_offsets(struct v3dv_cmd_buffer *cmd_buffer,
                                          data));
          break;
 
+      /* We generate this from geometry shaders to cap the generated gl_Layer
+       * to be within the number of layers of the framebuffer so we prevent the
+       * binner from trying to access tile state memory out of bounds (for
+       * layers that don't exist).
+       *
+       * Unfortunately, for secondary command buffers we may not know the
+       * number of layers in the framebuffer at this stage. Since we are
+       * only using this to sanitize the shader and it should not have any
+       * impact on correct shaders that emit valid values for gl_Layer,
+       * we just work around it by using the largest number of layers we
+       * support.
+       *
+       * FIXME: we could do better than this by recording in the job that
+       * the value at this uniform offset is not correct, and patch it when
+       * we execute the secondary command buffer into a primary, since we do
+       * have the correct number of layers at that point, but again, since this
+       * is only for sanityzing the shader and it only affects the specific case
+       * of secondary command buffers without framebuffer info available it
+       * might not be worth the trouble.
+       */
+      case QUNIFORM_FB_LAYERS: {
+         uint32_t num_layers;
+         if (job->frame_tiling.layers != 0) {
+            num_layers = job->frame_tiling.layers;
+         } else if (job->cmd_buffer &&
+                  job->cmd_buffer->state.framebuffer) {
+            num_layers = job->cmd_buffer->state.framebuffer->layers;
+         } else {
+            assert(job->cmd_buffer->level == VK_COMMAND_BUFFER_LEVEL_SECONDARY);
+            num_layers = 2048;
+#if DEBUG
+            fprintf(stderr, "Skipping gl_LayerID shader sanity check for "
+                            "secondary command buffer\n");
+#endif
+         }
+         cl_aligned_u32(&uniforms, num_layers);
+         break;
+      }
+
       case QUNIFORM_NUM_WORK_GROUPS:
          assert(job->type == V3DV_JOB_TYPE_GPU_CSD);
          assert(job->csd.wg_count[data] > 0);