Add a configuration option to reduce the available hardware range to a
fraction thereof. This is done by copying the absinfo struct for the
pressure value and adjusting that copy's minimum/maximum value for
scaling into the target normalized range.
The 1%/5% tip thresholds are kept but pressure offset detection is
disabled if there is a custom pressure range.
Unlike the pressure curve which is implemented in the compositor, the
pressure min/max range needs to be in libinput, primarily because the
tip threshold needs to adjust to any new minimum, allowing for
light touches with a pen without triggering tip down even at a higher
hardware pressure.
The new pre-commit hook introduced in commit 53517dccb8 ("Add
pre-commit hooks") found 2 files ending with a double empty line:
Fix End of Files.............................Failed
- hook id: end-of-file-fixer
- exit code: 1
- files were modified by this hook
Fix this error.
Signed-off-by: José Expósito <jose.exposito89@gmail.com>
detect_pressure_offset() currently rejects offsets that are greater than
20%. My graphics tablet (Wacom Bamboo Fun) is about 30%. The pen tip is
2 mm. Wacom recommends replacing at 1 mm, which means this isn't worn
out yet and we should instead increase the limit to make these devices
usable.
Without this change a "pen down" event happens simultaneously with the
pen being detected -- about 1 cm above the surface -- and producing
libinput pressure of about 0.30. This means you start drawing "in the
air", without knowing up front where the cursor is going to be.
Signed-off-by: Bjørn Forsman <bjorn.forsman@gmail.com>
This is a large commit because it's difficult to split this up and we don't
care about bisecting here anyway.
doxygen is going to produce the API documentation only
sphinx is going to produce the prose user (and a bit of developer) documentation.
The source split is doc/api and doc/user.
Steps performed:
- run the doxygen-to-sphinx.sh script to convert all .dox sources to .rst
- manually fixed the .rst to render correctly
- add a few extra .rst documents to generate the right hierarchy
- hook up sphinx-build in meson
- add a new @mainpage for doxygen more aimed at developers
For the build directory:
- sphinx produces /Documentation
- doxygen now produces /api/
These need to be manually combined in the wayland-web repo, meson doesn't
support subdirectories as output paths within the build dir and the
documentation doesn't need to be installed anywhere.
Signed-off-by: Peter Hutterer <peter.hutterer@who-t.net>
